ENGINE   113.940 /941 /942 /943 /948 /960 /961 /963 /965 /966 /967 /968 /969 ENGINE   137.970

Shown on Engine 119 55 Fuel filter 75 Fuel tank K27 Fuel pump relay module Model 129, 140, 202, 208 Model 210 as of 3/97 K40 Relay module model 170, model 210 up to 2/97 K40/4 Fuse and relay module Model 202 Model 210 as of 3/97 Model 163 designation F1 L5 Crankshaft position sensor M3 Fuel pump (FP) N3/10 ME-SFI control unit N16/1 Base module S2/1 Ignition/starter switch Y62 Injectors (LH-SFI, HFM-SFI, PEC [LH, HFM, PMS])
		P07.61-0377-06

Task Actuating fuel pump at Ignition ON: Actuate fuel pump for about 1 s (audible) as a full running protection. An engine start must be completed, however, before repeated actuation of the fuel pump. when starting engine via the first signals of the crankshaft position sensor (L5/5 on Engine 120) When engine running by means of TN engine speed signal. Design/function The fuel is actuated through the fuel pump relay. The fuel pump relay is actuated through a ground signal from the ME control unit. When the contact is closed, the fuel pump (M3) is linked through circuit 87 to circuit 30 (B+). The voltage supply is fused to the fuel pump.

On engine 120, the fuel pump is actuated by the right ME-SFI control unit (N3/12). If the fuel pump does not run, check the voltage supply of the ME control unit and the fuse of the fuel pump. Check electric connection at fuel pump for corrosion.

	Fuel pump location/task/design/function		GF47.20-P-4003L
	Engine speed signal function		GF07.61-P-3017F
	Crankshaft position sensor, location/task/design/function		GF07.04-P-4116F
	Fuel pump relay, location/task/design/function		GF54.15-P-4105L
	Motor electronics control unit, location/task/design/function		GF07.61-P-5000F
	Voltage supply of ME-SFI control unit function		GF07.61-P-5001F
	Electronic ignition switch control unit, location/task/design/function		GF80.57-P-4102S
	Ignition/starter switch (S2/1)	Circuitry of circuit 50 refer to wiring diagrams group 15, 54